Collection: Golf Clubmaking/Repairs

Replacement bolt and washer for the Ping G430, G425 & G410 Driver & Fairway.

Pack of 12 Black .370" Iron Ferrules.

Length .500", OD .540", ID .370".

All ferrules have a 19° countersink which allows a cushion of epoxy to form between the top of the hosel and the inside of the ferrule, strengthening the bond. Each ferrule also is “pre-washed,” arriving at your shop with a high-gloss finish and no need for an acetone wipe to make it shine!

Use these steel shaft butt extensions to extend shafts and increase the length of clubs. The extensions are double length. When cut in two, each section has an end tapered to fit inside the shaft being extended. Simply apply epoxy, slide the extender into the shaft butt, allow to try and cut to length.

To Fit .600" Butt Size

Ideal for fitting, use lead tape as temporary weight on the back of both wood and iron clubs to achieve correct total weight and swingweight. It is adhesive backed and can be applied quickly and easily or left on permanently. It will not damage wood finishes.

Small Roll, 1/2" wide, 100" long

The Callaway Advanced Opti-Force shaft adaptor allows for 9 different loft/face angle settings. Available in right hand for the following Callaway club heads

Fits:

• Rogue
• EpicGolfStoreProC
• Epic Flash (Driver)
• XR
• Big Bertha Alpha 815
• Big Bertha V Series
• Big Bertha
• Big Bertha Alpha
• X-Hot 2
• Opti-Force

Aftermarket.

Right Handed, fits a .335" shaft

The Authentic Ping shaft adaptor sleeve allows for multiple shafts to be used in the Ping G430/G425/G410 drivers and fairway woods at a fraction of the cost of re-shafting. Available in RH, .335". 

Genuine Ping and not Aftermarket

Short Roll of 2" solvent activated grip tape.

Premium quality, as used by professional club fitters and pro shops, enough tape to regrip approximately 14 clubs.