Collection: Golf Clubmaking/Repairs

Brass Shaft Tip Weights are epoxied into the shaft tip during assembly to achieve you desired swing weight. Suitable for .355" Taper Tip shafts. All weights have a full length hole to allow air escape when being epoxied. Can be cut or filled to reduce weight if necessary. 

Pack of 12 X Long Black .355" Tapered Iron Ferrules.

Length .875", OD .570", ID .355".

All ferrules have a 19° countersink which allows a cushion of epoxy to form between the top of the hosel and the inside of the ferrule, strengthening the bond. Each ferrule also is “pre-washed,” arriving at your shop with a high-gloss finish and no need for an acetone wipe to make it shine!

10 strips of 2" wide x 9" long solvent activated double sided golf grip tape.

Premium quality, as used by professional club fitters and pro shops.

PRO-FIX 5/10 shaft bonding adhesive, the first 5 minute adhesive with the strength, toughness of a 24 hour curing product. Playable strength is achieved within 10-30 minutes at standard temperature (allow longer for colder temps). Comes in easy dispense cartridges (No addiitional dispencing gun required). Net weight .85 FL. OZ. (25ml)

High quality aftermarket TaylorMade shaft adaptors allow for multiple shaft and length options to be used in the Qi35, Qi10, STEALTH, SIM, M1, M2, M3, M4, M5, M6, SLDR or R15 drivers and fairways for less than the cost of re-shafting.

Right Handed .335" - 4 Degree Adaptor.

36 Yard roll of 2" solvent activated professional grip tape.

Premium quality, as used by professional club fitters and pro shops, enough tape to regrip approximately 100-110 Clubs

The best epoxy money can buy, as used on the tour vans and by top club fitters. Enough for approx 50 clubs, required a 1:1 gun to dispense (sold separately).

When assembling clubheads these real Glass Shafting Beads can ensure that the golf shaft will be properly centered in the hosel. Mix the Glass Shafting Beads directly into your epoxy mix. The 4 ounce jar provides enough shafting beads for use in hundreds of clubs.

These shims are the perfect answer to your shaft installation headaches. Easy to use, they center the shaft in the bore perfectly and create a maximum bond between the shaft and the hosel. This shim is designed to convert a 0.355" iron shaft into a 0.370" hosel.

Replacement bolt and washer for the Ping G440, G430, G425 & G410 Driver & Fairway.

Wire brush suitable for .370" or .355" iron hosels. Quick and easy way to clean out old epoxy from hosels prior to fitting new shafts, for use with all drills.

Replacement bolt and washer for the Taylormade Qi35, Qi10, M3, M4, M5, M6, SIM & STEALTH Driver, Fairway & Rescue.